To obtain access to full text of journal and articles you must register!
- Article name
- Increasing the efficiency of electrical discharge machining of products made of granulated heat-resistant nickel alloy VV751P
- Authors
- ABLYAZ T. R., , lowrider11-13-11@mail.ru, Perm National Research Polytechnic University, Perm, Russia
SHLYKOV E. S., , Kruspert@mail.ru, Perm National Research Polytechnic University, Perm, Russia
BLOKHIN V. B., , warkk98@mail.ru, Perm National Research Polytechnic University, Perm, Russia
OSINNIKOV I. V., , ilyuhaosinnikov@bk.ru, Perm National Research Polytechnic University, Perm, Russia
MURATOV K. R., , karimur_80@mail.ru, Perm National Research Polytechnic University, Perm, Russia
- Keywords
- granulated heat-resistant nickel alloy VV751P / wire-cut electrical discharge machining / surface roughness / machining performance
- Year
- 2025 Issue 1 Pages 27 - 30
- Code EDN
- CVOAZE
- Code DOI
- 10.52190/2073-2562_2025_1_27
- Abstract
- The article studies the influence of wire-cut electrical discharge machining (WEDM) modes on the process productivity and surface quality parameter - roughness by Ra of granulated heat-resistant nickel alloy VV751P using brass and galvanized wire. The WEDM productivity was determined at minimum and maximum processing modes using brass wire and galvanized wire. An empirical dependence of the formation of the roughness parameter by Ra was obtained depending on the WEDM modes of products made of heat-resistant nickel alloy VV751P.
- Text
- BUY for read the full text of article
- Buy
- 500.00 rub
